Sell High-Temp Silicone Gasket Maker

1) Engine use 2) Replacement for cam covers, thermostat housing, intake manifold seals, transmission pans, water pums etc.

Product benefits:1) Hight temperature resistance.

2) Superior adhesion and flexibility3) Improved oil resistance4) Replaces most cut gaskets5) Can be used as a gasket maker or dressing6) Non-flammable, non-toxicTypical Applications: 1) Timing gear covers2) Transmission pans3) Valve covers4) Oil pans5) EngineDirection for Use: For assembly as form-in-place gasket1) Remove all previous material from mating surfaces. The product is recommendedfor most materials, not for plastics or painted surfaces2) For best results, clean and dry all surfaces with a residue-free solvent3) Cut nozzle to desired bead size, 1/16 to 1/4 in diameter. An 1/8 bead is usuallysufficient for most applications4) Remove cap, puncture tube or cartridge seal and attach extension nozzle5) Apply a continuous and even bead of silicone to one surface, first tracing theinternal areas of the gasket configuration, then all surrounding bolt holes.Removeexcess with knife at once, wait silicone to drying on skin (15-20 minutes)before assembling. Do not squeeze out silicone by over tightening bolts.6) Assemble parts immediately while silicone is still wet. Secure or tighten to recommended torque specs7) Silicone dries in 1 hour, and fully cures in 24 hours, measured at 70'F-50% relativehumidity8) Re-torque will not be necessary after the product has curedFor assembly as gasket dressing1) Repeat steps 1 thru 4 as in previous section2) Apply a thin film of silicone to one surface to be sealed3) Place the pre-cut gasket onto silicone film4) Apply a second thin to pre-cut gasket surface5) Remove any excess and assemble parts immediatelyNote:1) Not recommended for use on hand gaskets or parts continuous immersed in gasoline2) Not for use on oxygen sensor equipped vehiclesTechnical date: 1) Chemical type: oxime silicone rubber2) Specific gravity: 1.20 - 1.40 (23 Celsius degree)3) Tack free time: 20 - 40min4) Hardness: 20 - 35 JIS A5) Elongation: 200 - 300%6) Tensile strength: 1.0 - 2.0 MPa7) Withstand pressure: 10 MPa8) Working temperature range: -40 - +250°C9) Colors: red, black, blue10) Appearance: non-sag paste11) Odor: low odorStorage:Products shall be ideally stored in a cool, dry location in unopened containers ata temperature between 8 to 28 Celsius degree unless otherwise labeled. Optimalstorage is at the lower half of this temperature range. To prevent contaminationof unused product, do not return any material to its original container.Packing: 144 tubes/carton

Sell High-Temp Silicone Gasket Maker